LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1090 (Accessory Drive System) >> Removal And Installation >> Power Steering Pump Belt >> Installation

Power Steering Pump Belt: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering belt on the crankshaft pulley.
    2. CAUTION: After installation, make sure the belt is correctly seated on the crankshaft and power steering pulleys.
  2. Position the power steering belt around the special tool and the power steering pulley. Make sure that the belt is engaged with the power steering pulley and rotate the crankshaft clockwise to install the power steering belt.
    3. Fig 1: Positioning Power Steering Belt Around Special Tool (303-1252/2) & Power Steering Pulley
    GF0031435Courtesy of FORD MOTOR CO.
  3. Position the accessory drive belt on the crankshaft pulley.
    4. NOTE: After installation, make sure the belt is correctly seated on all pulleys.
  4. Working from the top of the vehicle, position the accessory drive belt on the generator pulley. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt.
  5. Install the RH inner fender splash shield. For additional information, refer to FRONT END BODY PANELS .
scientia non olet · About LEMON Manuals