Crankshaft End Play
WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Dial Indicator Gauge with Holding Fixture | 100-002 (TOOL-4201-C) or equivalent |
- Measure the crankshaft end play. Use a Dial Indicator Gauge with Holding Fixture to measure crankshaft end play.
- Position the crankshaft to the rear of the cylinder block.
- Zero the indicator.
- Move the crankshaft to the front of the cylinder block. Note and record the crankshaft end play.
- If crankshaft end play exceeds specifications, install a new crankshaft thrust washer or crankshaft thrust main bearing. For additional information, refer to the specification chart in the appropriate engine procedure. Refer to ENGINE - 2.3L , ENGINE - 3.0L (2V) or ENGINE - 4.0L SINGLE OVERHEAD CAMSHAFT (SOHC) for the procedure.