LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1080 (Engine) >> In-Vehicle Servicing >> Oil Cooler >> Removal

Oil Cooler: Removal

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Drain the cooling system. For additional information, refer to ENGINE COOLING .
  3. Remove the LH catalytic converter. For additional information, refer to EXHAUST SYSTEM .
  4. Disconnect the 2 coolant hoses from the oil cooler.
    5. CAUTION: If metal or aluminum material is present in the oil cooler, mechanical concerns exist. Failure to correct these concerns may cause engine failure. To diagnose mechanical concerns, refer to ENGINE SYSTEM - GENERAL INFORMATION .
  5. Remove the 6 bolts and the oil cooler.
    • Discard the gaskets.
    • Inspect the oil cooler.
    • Clean and inspect all sealing surfaces.
scientia non olet · About LEMON Manuals