LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1080 (Engine) >> In-Vehicle Servicing >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the seal lips and bore with clean engine oil prior to installation.
  1. Position the special tool onto the end of the crankshaft and slide a new crankshaft rear seal onto the tool.
    2. Fig 1: Positioning Special Tool (303-1250) Onto End Of Crankshaft
    GF0029111Courtesy of FORD MOTOR CO.
  2. Using the special tools, install the new crankshaft rear seal.
    3. Fig 2: Installing New Crankshaft Rear Seal Using Special Tools (303-1250) & (205-153)
    GF0029112Courtesy of FORD MOTOR CO.
  3. Install the crankshaft sensor ring.
  4. Install the flexplate. For additional information, refer to Flexplate .
scientia non olet · About LEMON Manuals