Stub Shaft Pilot Bearing and Seal: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Lubricate the new stub shaft pilot bearing housing seal with grease.

Using the special tools, install the stub shaft pilot bearing housing seal.

Fig 1: Installing Stub Shaft Pilot Bearing Housing Seal Using Special Tools (205-350) & (205-153)

Courtesy of FORD MOTOR CO.

CAUTION: Inspect the inboard CV joint seal journal for rust or nicks/scratches prior to installing the halfshaft. If necessary, polish the seal journal with fine crocus cloth.

Install the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS .