Drive Pinion Seal: Removal

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
Remove and discard the 4 rear driveshaft U-joint flange bolts.
- Support the driveshaft.

Fig 1: Locating Rear Driveshaft Universal Joint Flange Bolts

Courtesy of FORD MOTOR CO.

Using the special tool, hold the pinion flange and remove and discard the nut.

Fig 2: Identifying Special Tool (205-126)

Courtesy of FORD MOTOR CO.

Index-mark the location of the pinion to the yoke.

Fig 3: Identifying Index-Mark On Pinion Of Yoke

Courtesy of FORD MOTOR CO.

Using the special tool, remove the pinion flange.

Fig 4: Identifying Special Tool (205-D072)

Courtesy of FORD MOTOR CO.

Using the special tools, remove and discard the drive pinion seal.

Fig 5: Identifying Special Tool (307-309, 100-001)

Courtesy of FORD MOTOR CO.