Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that the mating surface is clean before installing the new seal.

Using the special tool, install the drive pinion seal.

Fig 1: Identifying Special Tool (205-133)

Courtesy of FORD MOTOR CO.

NOTE: Lubricate the pinion flange splines with grease.

Line up the index marks and position the pinion flange.

Fig 2: Lining Up Index Marks & Position Pinion Flange

Courtesy of FORD MOTOR CO.

Using the special tool, install the new pinion nut.
- Tighten to 244 Nm (180 lb-ft).

Fig 3: Identifying Special Tool (205-126)

Courtesy of FORD MOTOR CO.

Line up the index marks and install the rear driveshaft U-joint flange with 4 new bolts.
- Tighten to 70 Nm (52 lb-ft).

Fig 4: Locating U-Joint Flange Bolts

Courtesy of FORD MOTOR CO.