LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1068 (Front Suspension) >> Removal And Installation >> Lower Arm >> Installation

Lower Arm: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Do not tighten the bolt at this time.
  1. Position the lower arm and loosely install the 2 lower arm-to-frame rearward bolts.
    2. NOTE: Do not tighten the bolts at this time.
  2. Loosely install the lower arm-to-frame forward bolt and spacer.
  3. Install the lower arm ball joint bolt and nut.
    • Tighten to 55 Nm (41 lb-ft).
  4. Install the stabilizer bar link lower nut.
    • Tighten to 90 Nm (66 lb-ft).
  5. Install the wheel and tire. For additional information, refer to WHEELS AND TIRES .
  6. With the weight of the vehicle resting on the wheels and tires, tighten the lower arm-to-frame forward bolts to 150 Nm (111 lb-ft).
  7. With the weight of the vehicle resting on the wheels and tires, tighten the 2 lower arm-to-frame rearward bolts to 80 Nm (59 lb-ft).
  8. Check and, if necessary, align the front end. For additional information, refer to WHEELS AND TIRES .
scientia non olet · About LEMON Manuals