Rear Disc Brake: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Clean and dry the brake disc-to-hub mounting surface and apply a thin coat of anti-seize lubricant where indicated.

Fig 1: Applying A Thin Coat Of Anti-Seize Where Indicated

Courtesy of FORD MOTOR CO.

Install the brake disc onto the wheel hub.
Position the brake caliper and anchor plate assembly and install the 2 brake caliper anchor plate bolts.
- Tighten to 55 Nm (41 lb-ft).
Install the wheel and tire assembly. For additional information, refer to WHEELS AND TIRES .
Test the brakes for normal operation.