LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1063 (Noise, Vibration And Harshness) >> General Procedures >> Wheel Bearing Check

Wheel Bearing Check

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
    • Make sure the wheels are in a straight forward position.
    2. NOTE: Make sure the wheel rotates freely and that the brake pads are retracted sufficiently to allow free movement of the tire and wheel assembly.
  2. Spin the tire by hand to check the wheel bearings for roughness.
    3. Fig 1: Checking Wheel Bearings For Roughness
    GF0000033Courtesy of FORD MOTOR CO.
  3. Grip each front tire at the top and bottom and move the wheel inward and outward while lifting the weight of the tire off the front wheel bearing.
    4. Fig 2: Lifting Weight Off Of Tire Off Of Front Wheel Bearing
    GF0000034Courtesy of FORD MOTOR CO.
  4. If the tire and wheel (hub) is loose on the spindle, does not rotate freely, or has a rough feeling when spun, carry out one of the following:
    1. On vehicles with inner and outer bearings, inspect the bearings and cups for wear or damage. Adjust or install new bearings and cups as necessary.
    2. On vehicles with one sealed bearing, install a new wheel hub. For additional information, refer to FRONT SUSPENSION .
    5. Fig 3: Identifying Wheel (Hub) Components
    GF0004758Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals