LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1057 (Fuel Tank And Fuel Lines - (Hybrid)) >> Removal And Installation >> Fuel Lines >> Installation

Fuel Lines: Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel supply tube and fuel vapor tubes.
    • Make sure the retainer clips snap into place when installing onto the studs. Pull on the clips to make sure they are correctly seated.
  2. NOTE: Make sure the tubes are correctly snapped into the clip and the clip is snapped securely into the subframe.
  3. Install the fuel supply and fuel vapor tubes into the frame-mounted retainer clips.
  4. Connect the fuel vapor tube quick connect coupling onto the EVAP canister. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  5. Connect the fuel supply jumper tube quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  6. Connect the fuel vapor tube quick release coupling to the EVAP canister purge valve. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  7. Install the fuel vapor tube and connect the fuel vapor tube quick connect couplings to the intake manifold and the EVAP canister purge valve. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  8. Install the fuel supply tube and connect the quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  9. Connect the fuel tube-to-fuel rail quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  10. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  11. Turn the ignition key to the ON position to pressurize the fuel system.
  12. Visually inspect the fuel system for leaks.