Removal And Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Carefully detach the differential pressure feedback EGR sensor from the EGR valve tube and position aside.
- Disconnect the exhaust manifold-to-EGR valve tube fitting from the EGR valve.
- To install, tighten to 40 Nm (30 lb-ft).
- Disconnect the exhaust manifold-to-EGR valve tube fitting from the RH catalytic convertor.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the EGR valve tube.
- To install, reverse the removal procedure.