Electronic Engine Controls
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
The electronic engine controls consist of the following:
- PCM
- Engine coolant temperature (ECT) sensor
- Throttle position (TP) sensor
- Idle air control (IAC) valve
- Camshaft position (CMP) sensor
- Crankshaft position (CKP) sensor
- Mass air flow (MAF) sensor
- Heated oxygen sensor (HO2S)
- Catalyst monitor sensor
The PCM carries out the following functions:
- accepts input from various engine sensors to compute the fuel flow rate necessary to maintain a prescribed air/fuel ratio throughout the entire engine operational range.
- outputs a command to the fuel injectors to meter the appropriate quantity of fuel.
The ECT sensor:
- sends the PCM a signal indicating engine temperature.
- resistance decreases as coolant temperature increases.
The TP sensor:
- sends the PCM a signal indicating the throttle plate angle.
- is the main input to the PCM from the driver.
The IAC valve:
- controls bypass air around the throttle plate at low speeds.
- is controlled by the PCM.
The CMP sensor:
- sends the PCM a signal indicating camshaft position used for fuel synchronization.
The CKP sensor:
- sends the PCM a signal indicating crankshaft position.
- is essential for calculating spark timing.
The MAF sensor:
- uses a hot wire sensing element to measure the amount of air entering the engine. Air passing over the hot wire causes it to cool.
The HO2S:
- creates a voltage signal dependent on exhaust oxygen content.
- provides feedback information to the PCM used to calculate fuel delivery.
The catalyst monitor sensor:
- monitors oxygen content after it flows through the catalytic converter.
- provides a voltage to the PCM used to calculate catalytic converter integrity.