LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Cruise Control System -- F250-F550 Super Duty) >> Removal And Installation >> Speed Control Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. Vehicles without remote audio controls 

  3. Release the tabs and remove the speed control switches.
    • Cut the wire ties.
    • Disconnect the electrical connector.
      Fig 1: Disconnecting Electrical Connector (Vehicles Without Remote Audio Controls)
      G03889852Courtesy of FORD MOTOR CO.
  4. Vehicles with remote audio controls 

    CAUTION: When removing the speed control switch, be careful not to damage the leather wrap tied around the switch.
  5. Cut the wire ties and remove the speed control switch.
    • Disconnect the electrical connectors.
      Fig 2: Disconnecting Electrical Connector (Vehicles With Remote Audio Controls)
      G03924199Courtesy of FORD MOTOR CO.
  6. All vehicles 

    NOTE: New wire ties need to be installed when this procedure is complete to secure the steering wheel harness.
  7. To install, reverse the removal procedure.