Speed Control Deactivator Switch: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not allow brake fluid to contact the electrical connector.

Install the deactivator switch.
- Add a few drops of brake fluid to the fluid port on the threaded side of the switch before installing it.
  
  Fig 1: Adding Drops Of Brake Fluid To Fluid Port On Threaded Side Of Switch
  Courtesy of FORD MOTOR CO.
  
  Fig 2: Identifying Tightening Torque Of Speed Control Deactivator Switch
  Courtesy of FORD MOTOR CO.
Check the master cylinder fluid level and adjust as necessary.
Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .