Selector Lever: Removal

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
Place the selector lever in the (D) position.

Fig 1: Locating Floor Shift Selector Lever In (D) Position

Courtesy of FORD MOTOR CO.

Gently pry up to remove the upper selector lever trim ring.

Fig 2: Identifying Upper Shift Lever Trim Ring

Courtesy of FORD MOTOR CO.

NOTE: It may be necessary to apply the parking brake in order to remove the top finish panel.

NOTE: If necessary, disconnect the electrical connector from the finish panel.

Remove the top finish panel.

Fig 3: Locating Top Finish Panel

Courtesy of FORD MOTOR CO.

Remove the selector lever cable from the selector lever assembly.
1. Disconnect the selector lever cable end from the selector lever.
2. Remove the selector lever cable from the bracket.

Fig 4: Selector Lever Cable At Gearshift Assembly

Courtesy of FORD MOTOR CO.

Remove the shifter.
1. Disconnect the electrical connector.
2. Remove the 4 bolts and remove the selector lever assembly.

Fig 5: Selector Lever Assembly Electrical Connector & Bolts

Courtesy of FORD MOTOR CO.