Side Impact Sensor - Second Row, C-Pillar: Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connector to the side impact sensor.
- Align the side impact sensor locator tabs to the openings in the C-pillar sheet metal.
- Install the side impact sensor bolt.
- Tighten to 9 Nm (80 lb-in).
- Install the C-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
- Repower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
NOTE:
Make sure the C-pillar and side impact sensor mating surfaces are clean and free of foreign material.
WARNING:
The tightening torque of the air bag side impact sensor retaining bolt is critical for correct system operation.