Removal And Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Remove the RH front fender splash shield. For additional information, refer to FRONT END BODY PANELS article.
- Remove the rear window washer pump.
- Disconnect the electrical connector.
- Disconnect the hose.
- Remove the rear window washer pump.
- To install, reverse the removal procedure.
- Fill the windshield washer reservoir with windshield washer fluid.
WARNING:
Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the label of the washer solution container. Failure to follow these instructions may result in personal injury.
CAUTION:
When replacing the rear window washer pump, be careful not to damage the rubber grommet.
NOTE:
To prevent spilling windshield washer fluid, drain the windshield washer reservoir before washer pump removal.
WARNING:
Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the label of the washer solution container. Failure to follow these instructions may result in personal injury.
CAUTION:
Do not operate the windshield washer pump prior to filling the windshield washer reservoir. Failure to follow these instructions may result in premature pump failure.