LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1011 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Cowl Panel Grille >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 wiper pivot arms nuts.
    • To install, tighten to 35 Nm (26 lb-ft).
  2. Remove the LH and RH wiper pivot arms.
  3. Remove the 8 cowl panel grille pin-type retainers.
  4. Remove the 8 cowl panel grille caps and screws.
  5. Remove the LH cowl panel grille.
  6. Remove the RH cowl panel grille.
  7. To install, reverse the removal procedure.
    • Adjust the wiper pivot arms. For additional information, refer to WIPERS AND WASHERS article.
scientia non olet · About LEMON Manuals