Fuel Tank and Lines
The fuel tank and lines consists of the:
- saddle-type fuel tank.
- Fuel Pump (FP) module.
- Easy Fuel ™ (capless) fuel tank filler pipe assembly.
- fuel level sensor assembly.
- fuel level sender (mounted on FP module and the fuel level sensor assembly).
- fuel tubes.
- FP control module.
- Fuel Tank Pressure (FTP) sensor (part of the fuel vapor tube assembly).
The vehicle:
- uses a 2-speed Mechanical Returnless Fuel System (MRFS).
- has a dual-container (saddle-type) fuel tank.
- has a FP module that supplies fuel under pressure to the fuel rail.
- has a lifetime fuel filter (serviced as part of the FP module).
- has fuel tubes (liquid and vapor) along with brake tubes mounted on the underside of the vehicle in a bundle.
- fuel injection rail pressure is controlled by the electronic FP module which is enabled by the PCM.
- has an Easy Fuel ™ (capless) fuel tank filler pipe assembly, which cannot be modified in any way and is serviced only by installation of a new fuel tank filler pipe assembly.
- has a supplemental refueling adapter located in the spare tire compartment.
- has a FP module that operates on 10 or 12 volts depending on load, that supplies fuel under pressure to the fuel rail.
- has a FP control module located behind the RH C-pillar trim panel.
- has a fuel level vent valve (part of the fuel tank FP module).
- has a serviceable fuel level sender mounted on the FP module and fuel level sensor assembly.
The FP is controlled by the PCM. Electrical power to the FP is provided through the FP control module.