LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Charging System & Fuel Control System >> Removal And Installation >> Throttle Body >> Removal and Installation

Removal and Installation

  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Disconnect the electronic throttle control electrical connector.
  3. Remove the 4 bolts and the Throttle Body (TB).
    • Discard the TB  gasket.
    • To install, tighten to 10 Nm (89 lb-in).
    4. NOTE: Install a new TB  gasket.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals