Removal and Installation

NOTE: Do not use oil or grease-based lubricants on the isolators. They may cause deterioration of the rubber.

NOTE: Oil or grease-based lubricants on the isolators may cause the exhaust hanger isolator to separate from the exhaust hanger bracket during vehicle operation.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Support the muffler and tailpipe with a suitable jackstand.

Fig 1: Supporting Muffler And Tailpipe With Suitable Jackstand
Courtesy of FORD MOTOR CO.
Loosen the Torca® clamp nut.
- To install, tighten to 48 Nm (35 lb-ft).

NOTE: Do not damage or tear the isolators during removal.

Using soapy water, separate the 3 isolators and remove the muffler and tailpipe assembly from the vehicle.

NOTE: The intermediate pipe must be supported to prevent damage to the flexible pipe.

Using a length of mechanic's wire, support the intermediate pipe.
To install, reverse the removal procedure.
- Install a new gasket and nuts.
- Inspect and replace any isolators damaged or torn during the removal process.
Start the engine and check for exhaust leaks.