Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove and discard the 2-exhaust Y-pipe flange nuts.
- Discard the gasket.
- To install, tighten to 40 Nm (30 lb-ft).
- Loosen the Torca® clamp nut.
- To install, tighten to 48 Nm (35 lb-ft).
- Separate the exhaust intermediate pipe from the muffler and tailpipe and remove the exhaust intermediate pipe.
- To install, reverse the removal procedure.
- Always install new gaskets and exhaust fasteners.
- Start the engine and check for exhaust leaks.