Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Remove the RH catalytic converter. For additional information, refer to EXHAUST SYSTEM .
- Remove the block heater cover.
- Disconnect the block heater electrical connector.
- Remove the block heater.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.
- Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
NOTE:
Make sure that the block heater wiring is routed and secured away from rotating or hot components, or damage to the wiring may occur.