LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Engine Mechanical >> Auxiliary Emission Control Systems >> Evaporative Emissions System >> General Procedures >> Evaporative Emission System Leak Test >> Phase 1 - Leak Verification

Phase 1 - Leak Verification

  1. Run the EVAP  Test with the scan tool.
    2. NOTE: Some small leaks may not be detected using the EVAP  Test. If the system has passed the test but a leak is still suspected, then proceed to Phase 2.
  2. If the Evaporative Emission (EVAP) system failed the EVAP  Test, then proceed to Phase 2.
scientia non olet · About LEMON Manuals