LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Charging System (Battery, Mounting And Cables) >> Removal And Installation >> Battery Cables >> Removal and Installation

Removal and Installation

  1. Remove the battery tray. For additional information, refer to BATTERY TRAY .
  2. Remove the bolt and position the battery cable body ground terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  3. Remove the nut and position the Battery Junction Box (BJB) cable terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  4. Remove the starter solenoid terminal cover.
  5. Remove the starter solenoid terminal nut and position the battery cable starter solenoid terminal aside.
    • To install, tighten to 6 Nm (53 lb-in).
  6. Remove the starter B+ nut and position the battery cable starter motor terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  7. Release the battery cable locator from the engine.
  8. Remove the bolt and position the battery cable engine ground terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  9. Release the battery cable from the top of the intake manifold.
  10. Release the 3 battery cable locators from the LH valve cover.
  11. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
    • To install, tighten to 17 Nm (150 lb-in).
  12. Remove the battery cables.
  13. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals