LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel & Console >> Removal And Installation >> Instrument Cluster Finish Panel >> Removal and Installation

Removal and Installation

  1. Adjust the steering wheel to the full down position.
  2. Remove the LH instrument panel finish panel.
    • With a non-marring tool, pry the LH instrument panel side trim panel outward to release the retaining clips.
    Fig 1: Locating LH Instrument Panel Finish Panel
    G06071116Courtesy of FORD MOTOR CO.
  3. Remove the center instrument panel finish panel. For additional information, refer to INSTRUMENT PANEL FINISH PANEL - CENTER .
  4. Using a non-marring tool, open the 2 instrument cluster finish panel upper screw covers.
  5. Remove the 2 instrument cluster finish panel upper screws.
  6. Remove the instrument cluster finish panel lower screw.
  7. Remove the instrument cluster finish panel.
    • Disconnect the electrical connectors.
  8. To install, reverse the removal procedure.
    • Make sure to align the retaining clips to the adjacent retaining clip holes.
scientia non olet · About LEMON Manuals