Instrument Cluster (IC): Installation
- Position the IC in the instrument panel, connect the electrical connector and install the 4 screws.
- Install the IC finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- If installing a new IC , download the IC configuration information from the scan tool into the new IC . For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
- If installing a new IC , carry out the parameter reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
- If installing a new IC , carry out the PATS key programming. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
NOTE:
If a new IC
is installed, the IC
and the PCM require a parameter reset to allow the IC
and the PCM to recognize each other. Failure to carry out the parameter reset to the IC
and the PCM results in a no start condition.
NOTE:
The vehicles Passive Anti-Theft System (PATS) keys must be programmed to the new IC
.