LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center, & Warning Chimes >> DIAGNOSIS and TESTING >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AG: The Headlamps On Warning Chime Is Inoperative >> Pinpoint Test Ag: The Headlamps On Warning Chime Is Inoperative

Pinpoint Test Ag: The Headlamps On Warning Chime Is Inoperative

  1. AG1 CARRY OUT THE CHIME FUNCTION ACTIVE COMMAND 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: IC  DataLogger.
    • Select the IC  chime command (CHIME_H_LMP).
    • Does the chime operate? 
    • Yes  : GO to AG2.
    • No  : INSTALL a new IC  . REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation.
  2. AG2 CHECK THE HEADLAMP OPERATION 
    • Ignition OFF.
    • Place the headlamp switch in the HEADLAMP position.
    • Do the headlamps operate? 
  3. AG3 CHECK THE DOOR AJAR WARNING INDICATOR OPERATION 
    • Ignition ON.
    • Open then close the LH front door while observing the door ajar warning indicator in the IC  .
    • Does the door ajar warning indicator operate correctly? 
scientia non olet · About LEMON Manuals