Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the wheel speed sensor electrical connector.
- Detach the 2 wheel speed sensor pin-type retainers.
- Detach the 2 wheel speed sensor harness retainers.
- Remove the wheel speed sensor bolt.
- To install, tighten to 15 Nm (133 lb-in).
- Remove the wheel speed sensor.
- To install, reverse the removal procedure.
NOTE:
Make sure to correctly route and secure the wheel speed sensor harness in the rear subframe assembly or damage to the harness may occur.