Pinpoint Test F: DTC B2900
- F1 VERIFY PCM VIN
- Connect the scan tool.
- Ignition ON.
- Using the scan tool, carry out the Network Test.
- Enter the following diagnostic mode on the scan tool: Log Viewer.
- Compare the VIN
in Log Viewer to the vehicle VIN
plate.
- Does VIN in Log Viewer match the vehicle VIN plate?
- Yes
: GO to F2.
- No
: RECONFIGURE the PCM. FOLLOW the instructions on the scan tool. CLEAR the DTCs. CYCLE the ignition key. REPEAT the self test.
- F2 VERIFY ABS MODULE PART NUMBER
- Retrieve and record the ABS module part number from Log Viewer and verify that the vehicle has the correct ABS module installed.
- Is the correct ABS module installed in the vehicle?
- Yes
: CONFIGURE the ABS module. REFER to Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is NOT Available in
MODULE CONFIGURATION
. CLEAR the DTC. CYCLE the ignition key. REPEAT the self test.
- No
: INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) MODULE . CLEAR the DTC. CYCLE the ignition key. REPEAT the self test.