Adjustable Pedals

Visually inspect for obvious signs of mechanical or electrical damage.

VISUAL INSPECTION CHART

Mechanical	Electrical
Adjustable brake pedal cable Adjustable pedal motor Adjustable brake and accelerator pedals Foreign material	Adjustable pedal switch Driver Seat Module (DSM) Memory SET switch Remote Keyless Entry (RKE) transmitter Battery Junction Box (BJB) fuse 32 (30A) Smart Junction Box (SJB) fuse 13 (5A) Wiring, terminals or connectors

If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.

NOTE: Make sure to use the latest scan tool software release.

If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).

NOTE: The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM .

If the scan tool does not communicate with the VCM :
- check the VCM connection to the vehicle.
- check the scan tool connection to the VCM .
- refer to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
If the scan tool does not communicate with the vehicle:
- verify the ignition is ON.
- verify the scan tool operation with a known good vehicle.
- refer to MODULE COMMUNICATIONS NETWORK to diagnose no response from the PCM.
Carry out the network test.
- If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK .
- If the network test passes, retrieve and record Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Clear the continuous DTCs and carry out the self-test diagnostics for the Driver Seat Module (DSM).
If the DTCs retrieved are related to the concern, go to DRIVER SEAT MODULE (DSM) DTC CHART . For all other DTCs, refer to the Master DTC Chart in MULTIFUNCTION ELECTRONIC MODULES .
If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART - ADJUSTABLE PEDALS .