LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Front Disc Brake System >> Removal And Installation >> Brake Caliper Anchor Plate >> Removal

Brake Caliper Anchor Plate: Removal

  1. Remove the brake pads. For additional information, refer to BRAKE PADS .
  2. Remove and discard the 2 brake caliper anchor plate bolts and remove the brake caliper anchor plate.
    3. NOTE: Do not remove the anchor plate guide pins. The guide pins are press fit to the brake caliper anchor plate. If the guide pins are damaged, a new anchor plate must be installed.
  3. Inspect the brake caliper anchor plate assembly.
    • Check the guide pins and boots for binding or damage.
    • Install a new brake caliper anchor plate if it is worn or damaged.
scientia non olet · About LEMON Manuals