Windshield Glass: Installation

NOTE: For additional material guidelines, refer to the manufacturer's installation information.

Dry fit the windshield glass to the existing urethane adhesive bead on the body pinch weld. Align the windshield glass in the opening for a uniform fit.
Use a non-permanent pencil to make alignment marks on the windshield glass at the setting blocks (if equipped) and the body to aid in the installation alignment of the windshield glass.
Remove the windshield glass and place on a stable surface.
WARNING: Repair any corrosion found on the pinch weld. The pinch weld is a structural component of the vehicle. Corrosion left unrepaired may reduce the structural integrity of the vehicle. Failure to follow this instruction may result in serious injury to vehicle occupant(s).

NOTE: Avoid scratching the pinch weld. Repair all minor scratches or exposed metal on the pinch weld following manufacturer's instructions. Use the same brand pinch weld primer, glass primer and urethane adhesive.

Using an appropriate tool, trim the urethane adhesive leaving a 1-2 mm (0.04-0.08 in) base of original equipment urethane adhesive on the pinchweld.

Fig 1: Trimming Urethane Adhesive Using Appropriate Tool
Courtesy of FORD MOTOR CO.
Using a soft brush or vacuum, remove any dirt or foreign material from the pinch weld.
If installing the original windshield glass, remove the excess urethane adhesive.
Clean the inside of the windshield glass surface with glass cleaner.
NOTE: Be sure to use the same brand and cure-rate products for the urethane adhesive and glass primer. Do not mix different brands of urethane adhesive and glass primer. For additional information, refer to the Material Chart.

If installing a new windshield glass, apply glass primer according to manufacturer's instructions. Allow at least 6 minutes to dry.
Cut the urethane adhesive applicator tip to specification.

Fig 2: Cutting Urethane Adhesive Applicator Tip
Courtesy of FORD MOTOR CO.
NOTE: Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane adhesive with less effort and continuous bead.

Apply urethane adhesive on top of the existing trimmed urethane adhesive bead on the pinch weld, starting and ending at the bottom of the windshield near the center, making sure there are no gaps in the bead.

Fig 3: Applying Urethane Adhesive On Top Of Existing Trimmed Urethane Adhesive Bead On Pinch Weld
Courtesy of FORD MOTOR CO.
Install the windshield glass on the vehicle aligning it with the markings made previously.
WARNING: Do not drive vehicle until the urethane adhesive seal has cured. Follow urethane adhesive manufacturer's curing directions. Inadequate or incorrect curing of the urethane adhesive seal will adversely affect glass retention. Failure to follow these instructions may result in serious injury to vehicle occupant(s).

After the urethane adhesive has cured, check the windshield glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as necessary.
Position the front portion of the headliner.
Install the LH and RH sun visors and clips.
Install the passenger front assist handle.
Install the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Install the interior rear view mirror. For additional information, refer to REAR VIEW MIRRORS .
Install the A-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Install the cowl panel grille upper and the cowl panel grille side mouldings. For additional information, refer to FRONT END BODY PANELS .
Install the exterior A-pillar window mouldings. For additional information, refer to EXTERIOR TRIM AND ORNAMENTATION .
Clean the interior and exterior windshield glass with glass cleaner.