Removal and Installation
- Remove the rear door fixed glass. For additional information, refer to WINDOW GLASS - FIXED, REAR DOOR .
- Temporarily install the window control switch and position the window glass to access the glass-to-regulator clamp locking tab.
- Using a suitable tool, push the glass-to-regulator clamp locking tab inward then gently lift the glass upward slightly to release the glass from the regulator clamp.
- To install, gently push glass down into the clamp until an audible click is heard, indicating the glass has seated correctly into the glass clamp.
- Remove the door window glass out through the top outboard side of the door.
- To install, reverse the removal procedure.