Removal and Installation
NOTE:
The LF window motor must be de-initialized, then initialized whenever the window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.
- Remove the window control switch. For additional information, refer to WINDOW CONTROL SWITCH .
- Remove the front door speaker. For additional information, refer to INFORMATION AND ENTERTAINMENT SYSTEMS .
- Position aside the water shield.
- Remove the interior door glass weatherstrip.
- Temporarily install the window control switch and lower the window glass to access the glass-to-regulator clamp locking tabs.
- Using a suitable tool, push each glass-to-regulator clamp locking tab inward then gently lift the glass upward slightly to release the glass from the regulator clamp.
- To install, gently push glass down into the clamps until an audible click is heard, indicating the glass has seated correctly into the glass clamps.
- Tip the front of the glass down and pull the front door window glass out through the top outboard side of the door.
- To install, reverse the removal procedure.
- For LF only, de-initialize, then initialize the window motor. For additional information, refer to WINDOW MOTOR INITIALIZATION .