De-initialization procedure

Turn the ignition key ON.
Operate the window control switch in one-touch mode and remove power from the window motor while the window is moving , by one of the following methods:
- Disconnect the vehicle battery cable while the window is moving .
- Disconnect the window motor connector while the window is moving .
- Remove the LH front window motor fuse while the window is moving .
This will de-initialize the window motor and reset the window motor to its original factory settings.
Re-connect the battery cable, window motor connector or re-install the LH front window motor fuse and carry out the initialization procedure to turn the one-touch up feature on.
Initialization procedure

NOTE: The LH front window must be in the full OPEN position for this procedure to operate correctly.

NOTE: If the initialization procedure is only partially completed, the LH front window motor will remain un-initialized and will not operate in one-touch up mode.
Turn the ignition key ON.
Activate and hold the window control switch in the UP position at the second detent until the window glass stalls for 2 seconds into the glass top run and release the switch.
Activate and hold the window control switch in the DOWN position at the second detent until the window glass stalls for 2 seconds at the bottom of its travel and release the switch.
Test for correct window operation by carrying out the one-touch up and one-touch down features.