Pinpoint Test G: The One-Touch Up/Down Feature Is Inoperative - LH Front Window Only

NOTE: Use the correct probe adapter(s) from the Flex Probe Kit when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

G1 CHECK FOR POWER (B+) LOSS DURING WINDOW OPERATION
- Verify if power (B+) was lost during window operation.
- Was power (B+) lost while the LH front window was in operation?
- Yes : RAISE the LH front window to the fully closed position. VERIFY the window glass stalls into the upper header seal. The window should function normally. TEST the system for normal operation.
- No : GO to G2.
G2 DE-INITIALIZE, THEN INITIALIZE THE LH FRONT WINDOW MOTOR
- De-initialize the LH front window motor, then carry out the window motor initialization procedure. Refer to WINDOW MOTOR INITIALIZATION .
- Is the one-touch up feature operating correctly?
- Yes : The system is operating normally at this time. The LH front window motor lost initialization.
- No : GO to G3.
G3 CHECK THE LH FRONT WINDOW CONTROL SWITCH
- Ignition OFF.
- Disconnect: LH Front Window Control Switch C504.
- Carry out the LH front window control switch component test.
  Refer to SYSTEM WIRING DIAGRAMS for component testing.
- Did the LH front window control switch pass the component test?
- Yes : INSTALL a new LH front window regulator motor. REFER to WINDOW REGULATOR MOTOR - FRONT DOOR . INITIALIZE the window motor. REFER to WINDOW MOTOR INITIALIZATION . TEST the system for normal operation.
- No : INSTALL a new LH front window control switch. REFER to WINDOW CONTROL SWITCH . TEST the system for normal operation.