Pinpoint Test B: All Passenger Power Windows Are Inoperative

NOTE: Use the correct probe adapter(s) from the Flex Probe Kit when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

B1 CHECK PASSENGER WINDOW OPERATION FROM THE LH FRONT WINDOW CONTROL SWITCH
NOTE: Make sure the LH front window control switch is in the UNLOCK position.
- Ignition ON.
- Attempt to operate the passenger windows from the LH front window control switch.
- Do the passenger windows operate from the LH front window control switch?
- Yes : GO to B2.
- No : VERIFY Smart Junction Box (SJB) circuit breaker 47 (30A) is OK. If OK, REPAIR open in circuit CBP47 (GN/BU). TEST the system for normal operation.
If not OK, REFER to the appropriate System Wiring Diagrams to identify the possible causes of the circuit short. REPAIR the circuit. TEST the system for normal operation.
B2 CHECK THE LH FRONT WINDOW CONTROL SWITCH
- Ignition OFF.
- Disconnect: LH Front Window Control Switch C504.
- Carry out the LH front window control switch component test.
  Refer to SYSTEM WIRING DIAGRAMS for component testing.
- Did the window control switch pass the component test?
- Yes : REPAIR open in circuit CPW14 (VT/WH). TEST the system for normal operation.
- No : INSTALL a new LH front window control switch. REFER to WINDOW CONTROL SWITCH . TEST the system for normal operation.