Glass, Frames and Mechanisms: Notes
NOTE:
The Smart Junction Box (SJB) may also be identified as the Generic Electronic Module (GEM).
The glass, frames and mechanisms consist of the following:
- Accessory delay relay
- Front door glass top run
- Front door window glass
- Front door window regulator and motor
- HVAC module
- Rear door fixed glass and top run
- Rear door glass run retainer
- Rear door window glass
- Rear door window regulator and motor
- Rear quarter glass
- Rear window glass
- Rear window defrost grid
- Rear window defrost relay
- Roof glass panel (if equipped)
- Window control switches
- SJB
- Windshield glass
The glass, frames and mechanisms include the following:
- Standard plastic and laminate windshield glass
- Rear window glass, which houses the rear defrost grid and rear wiper
- Windshield glass, which is bonded to the opening flange with a urethane adhesive
- Standard power windows, which include one-touch up, one-touch down and lock-out feature (left front only)
The window regulator control switch:
- is located on each door trim panel.
- may be used to raise or lower all windows from the left front window control switch, or the individual side window from the corresponding individual door switch.
- can lock out passenger front and rear window control switches when the lock-out switch on the left front window control switch is turned on.
- can automatically lower the driver door window when the window control switch is momentarily pressed into the second detent position and released.
- can automatically raise the driver door window when the window control switch is momentarily pulled to the second detent position and released.