Removal and Installation

Place the roof opening panel glass in the full OPEN position.
From top of vehicle, depress spring steel locating tab downward on each side with flat-blade screwdriver while pushing deflector toward rear of vehicle.
- To install, make sure locating tabs are firmly locked in place.
Fig 1: Locating Spring Steel Locating Tab
Courtesy of FORD MOTOR CO.
Tilt the air deflector upward and pull forward to remove.

Fig 2: Tilting Air Deflector Upward
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Initialize the roof opening panel motor. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .