Roof Opening Panel Manual Operation

Remove the LH and RH A-pillar trim panels.
Remove the LH and RH sun visor assemblies.
Remove the sun visor clip retainer screws and remove the sun visor clips.

Fig 1: Locating Sun Visor Clip Retainer Screws
Courtesy of FORD MOTOR CO.
Remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
If equipped, disconnect the auto-dimming electrical connector from the interior rear view mirror.
Pull down front of headliner to gain access to the roof opening panel motor.
Insert an Allen wrench into the center of the manual drive hole. Rotate the Allen wrench counterclockwise until the roof opening panel is closed.

Fig 2: Inserting An Allen Wrench Into Center Of Manual Drive Hole

Courtesy of FORD MOTOR CO.