LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Seating >> Removal And Installation >> Seat Recliner - Inboard, Second Row, 60 Percent >> Removal and Installation

Removal and Installation

  1. Remove the 60 percent seat from the vehicle. For additional information, refer to SEAT - SECOND ROW .
  2. Remove the 60 percent rear seat backrest. For additional information, refer to SEAT BACKREST - SECOND ROW, 60 PERCENT .
  3. Remove the pin-type retainer, screw and the RH recliner cover.
  4. Remove the 3 RH recliner-to-riser bolts.
    • To install, tighten to 36 Nm (27 lb-ft).
    5. NOTE: Note cable routing for installation.
  5. Remove the cushion frame yoke-to-RH recliner bolt, detach the cable and remove the RH recliner.
    • To install, tighten to 42 Nm (31 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals