Removal and Installation
- Remove the 2 screw and pull the cushion handle out of the pocket.
- Separate the pivot release cable and casing and remove the pivot release handle.
- Remove the 2 screws on each side at the bottom of the load floor panel.
- Pull out to release the retainers and remove the load floor panel.
- Use a suitable tool to disengage the load floor from the seat.
- Remove the screw, release the tab and remove the floor latch cover.
- Release the cushion trim cover retainers from the cushion frame.
Courtesy of FORD MOTOR CO.
- Remove 2 rows of 3 hog rings and remove the cushion trim cover.
- On assembly, the lower anchors and tethers for children and child safety seat tether anchor must be accessible through the trim cover.
- To install, reverse the removal procedure.