Removal and Installation

Fold the 60 percent seat up to the E-Z entry position.
From under the seat, release 2 sets of cushion trim cover J-clips.
From under the seat, release the hook-and-loop strip and J-clip at the RH side of the cushion frame.
Release the cushion trim cover retainer from the outboard side of the cushion frame.
- Pull the cushion trim cover outboard retainer out from between the riser and the cushion frame.
  
  Fig 1: Locating Cushion Trim Cover Outboard Retainer
  Courtesy of FORD MOTOR CO.
Position the second row 60 percent seat down.
Remove the cushion trim cover from the cushion foam pad.
To install, reverse the removal procedure.
- Make sure the lower anchor and tether for children wires at the rear of the cushion frame are positioned through the cushion trim cover and accessible for use after installation.