Seat Backrest Heater Mat - Second Row, 40 Percent: Installation

NOTE: Always install a new backrest foam pad and new backrest heater mat together.

Install a new backrest heater mat onto a new backrest foam pad.
1. Route the backrest heater mat wire harness and electrical connector through the backrest foam pad to the other side.
2. Position the backrest heater mat onto the backrest foam pad so the opening aligns to the wire in the backrest foam pad.
  - Tuck the backrest heater mat into the backrest foam pad trench.
3. Make sure the backrest heater mat stays in place, remove the paper strips from under the backrest heater mat and adhere to the backrest foam pad, laying it flat with no wrinkles.
4. Position the wire harness in the foam pad notch.
  
  Fig 1: Identifying Backrest Foam Pad And Backrest Heater Mat
  Courtesy of FORD MOTOR CO.
Install the backrest foam pad onto the backrest frame.
Connect the backrest heater mat electrical connector.
Tuck the heater mat wire harness between the inboard pivot cover and pivot.
Install the backrest trim cover. For additional information, refer to SEAT BACKREST COVER - SECOND ROW, 40 PERCENT .