Removal and Installation
- Remove the head restraint.
- With the backrest folded down, release the backrest trim cover lower J-clip.
- Separate and remove the outer pivot cover.
- Release the 2 backrest trim cover inside J-clips to hard back panel.
- If equipped, disconnect the backrest heater mat electrical connector and route through the backrest trim cover.
- Release the hook-and-loop strips, invert the backrest trim cover and remove the 2 rows of hog rings.
- Release the hook-and-loop strips and invert the backrest trim cover to the top of the backrest.
- Lift the backrest foam pad, squeeze the tabs in and remove the 2 head restraint guides.
- Remove the backrest trim cover.
- To install, reverse the removal procedure.
NOTE:
Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the seat backrest foam.
NOTE:
The head restraint guides are not interchangeable.