Seat Backrest - Second Row, 40 Percent: Installation

Position the backrest frame and hand start all bolts.
Install the backrest frame bolts in the following sequence.
1. Install the lower recliner-to-backrest frame bolt.
  - Tighten to 50 Nm (37 lb-ft).
2. Install the upper recliner-to-backrest frame bolt.
  - Tighten to 50 Nm (37 lb-ft).
3. Install the pivot bolt.
  - Tighten to 22 Nm (16 lb-ft).
    
    Fig 1: Identifying Backrest Frame Bolts In Sequence
    Courtesy of FORD MOTOR CO.
If equipped, connect the heater mat electrical connector.
Reposition the backrest trim cover over the 2 recliner-to-backrest frame bolts.
Attach the outer pivot cover on the inboard side of the seat.
Attach the 2 backrest trim cover inside J-clips to the hard back panel.
Attach the backrest trim cover lower J-clips.