Seat Backrest - Second Row, 60 Percent: Assembly
- Position the safety belt retractor key through the backrest frame keyway.
- Position the inner safety belt guide into the backrest frame slot.
- Hand start the inner safety belt guide bolts and safety belt retractor bolt.
- Install the 3 bolts in the following sequence.
- Tighten the RH inner safety belt guide bolt to 23 Nm (17 lb-ft).
- Tighten the LH inner safety belt guide bolt to 23 Nm (17 lb-ft).
- Tighten the safety belt retractor bolt to 40 Nm (30 lb-ft).
- Align the backrest panel to the backrest frame and install 5 screws.
- Feed the safety belt through the backrest trim cover and backrest foam pad.
- Align the holes in the backrest trim cover to those in the backrest frame and foam pad.
- Roll the backrest trim cover down to where the top row of hog rings attaches and stop.
- Attach the hook-and-loop strips.
- Install the 2 rows of hog rings, roll the backrest trim cover down and attach the hook-and-loop strips.
- Install the outer safety belt trim guide.
- Install the 4 head restraint guides.
- Install the head restraints.
- Install the 60 percent seat backrest. For additional information, refer to SEAT BACKREST - SECOND ROW, 60 PERCENT .
- Install the 60 percent seat from the vehicle. For additional information, refer to SEAT - SECOND ROW .
- Make sure the safety belts and buckles are accessible to the occupants after installation.
- Verify the safety belt retractor operates without excessive effort or binding.
NOTE:
The head restraint guides are not interchangeable.