Quad Bucket and 40 Percent Backrest

NOTE: LH shown, RH similar.

Fig 1: Identifying Second Row, 40 Percent Seat Backrest Components

Courtesy of FORD MOTOR CO.

ITEM DESCRIPTION CHART

Item	Part Number	Description
1	66601	Backrest trim cover
2	14D696	Backrest heater mat (power-fold seat only, if equipped)
3	66801	Backrest foam pad
4	W790112	Pivot bolt
5	501A04	Head restraint trim cover
6	611A08	Head restraint assembly
7	610A16	Head restraint guide, slave
8	610A16	Head restraint guide, master
9	56910	Backrest hard back panel-to-backrest frame screws (4 required)
10	60508	Backrest hard back panel, RH quad bucket
10	60509	Backrest hard back panel, LH quad bucket
10	60508	Backrest hard back panel, 40 percent
11	W790117	Recliner-to-backrest bolts
12	613A38	Backrest frame, RH quad bucket or 40 percent
12	613A39	Backrest frame, LH quad bucket

Remove the seat. For additional information, refer to SEAT - SECOND ROW .
Remove the seat backrest. For additional information, refer to SEAT BACKREST - SECOND ROW, 40 PERCENT .
Remove the head restraint assembly.

NOTE: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the seat backrest foam.

Release the hook-and-loop strips, invert the backrest trim cover, remove the 2 rows of hog rings and invert to the top of the backrest frame.
- If equipped, route the heated seat wire harness around the backrest trim cover.
Remove 4 screws and the backrest hard back panel.

NOTE: The head restraint guides are not interchangeable.

Squeeze the tabs in and remove the 2 head restraint guides.
Remove the backrest trim cover.

NOTE: Always install a new backrest foam pad and new backrest heater mat together.

Remove the backrest foam pad.
- If equipped, note heater mat wiring harness routing for installation.
To assemble, reverse the disassembly procedure.